Multi-Spindle

Multi-Spindle CNC

 Tornos

Kaddis Manufacturing made a substantial investment in the “next generation” multi-spindle equipment. We did an in-depth analysis of what would complement our existing line of equipment and found that Tornos had the machine for Kaddis. Using automatic bar loaders for optimum efficiency, this equipment is designed for High Volume, Complex Parts maintaining Tight Tolerances.

Since 2002, Kaddis has purchased seven CNC Tornos Multi-Deco machines as follows:

  • 2 Six Spindle CNC Tornos Multi-Deco 26/6 - 17 Axis
  • 2 Six Spindle CNC Tornos Multi-Deco 32/6 - 18 Axis
  • 2 Eight Spindle CNC Tornos Multi-Deco 20/8 - 23 Axis
  • 1 Six Spindle CNC Tornos Multi-Deco 20/6 - 18 Axis
The capacity range for this equipment is:
  • Round Bar: ¼” (6mm) to 1 ¼” (32mm)
  • Hexagon Bar: ¼” (6mm) to 1” (25mm)
  • Square Bar: ¼” (6mm) to 7/8” (22mm) 

Multi-Spindle

 Acme

In 2005, Kaddis Manufacturing upgraded the Acme-Gridley department. Equipment remanufactured to OEM specs was put in place A Tech-Drive system was added for better control over Speeds and Feeds, which can result in a faster cycle time and savings for our customers.

Kaddis has 5 Acme-Gridley machines as follows:

  • 4 Six Spindle Acme Gridley
  • 1 Six Spindle Acme Gridley – Tech-Drive

The capacity range for this equipment is:

  • Round Bar: 1/2” (13mm) to 1 ¼” (32mm)
  • Hexagon Bar: 1/2” (13mm) to 1” (25mm)
  • Square Bar: ½” (13mm) to 7/8” (22mm)

Davenport

 Kaddis Manufacturing’s Davenport equipment undergoes a complete remanufacture every seven years by Kaddis personnel.  We believe Kaddis is the only machining company that remanufactures Davenports to “Better than New” standards. The Davenport machine is stripped down to the base casting. By using unique proprietary methods and controls we ensure Three Dimensional Alignment on the revolving and stationary heads. We are able to reduce the spindle to spindle tolerance to within ten thousandths instead of thousandths of an inch. This translates into less variation from spindle to spindle or part to part. A Davenport machine remanufactured at Kaddis equals Quality Equipment, Cost Contained, and World Class Parts.

Kaddis has Davenport machines as follows:

  • 40 Five Spindle Davenports
  • 6 Five Spindle Davenport Chuckers

The capacity range for this equipment is:
 

  • Round Bar: 1/8” (3mm) to ¾” (20mm)
  • Hexagon Bar: 1/8” (3mm) to 5/8” (16mm)
  • Square Bar: 1/8” (3mm) to 9/16” (14mm)